Illuminate & Cultivate · Studio Index

Find a room plan, frost zone, or spec

Studio LookbookVisual & Calculator Pillars
Interactive Planning Studios6 tools
USDA Frost-Zone Specimens (18 Zones)
Lighting, Paint & BTU Blueprints4 specs
DIY & RemodelDual Yard Blueprint

Deck Lumber & Patio Paver Base Calculator

Switch seamlessly between lumber deck framing (2×6 decking, 16-inch on-center joists, piers, fasteners) and compacted interlocking patio paver subbase tonnage.

16
12
Paver Area
211 sq ft
Net 192 +10%
4" Gravel Base
3.2 tons
2.37 cu yd
1" Bedding Sand
0.59 yd³
3× 50lb poly sand
Edge Restraint
56 lin ft
Paver Sub-Base Cross-Section & Running-Bond Plan16′ × 12′ (192 sq ft)
SUB-BASE LAYER SECTION (1/8"/FT SLOPE)HOUSE WALLTamped Subsoil Base4" Crushed Gravel (3.2 tons)1" Bedding Sand (0.59 yd³)Edge Restraint (56 ft)TOP-DOWN FOOTPRINT PLAN16′ Length × 12′ Width

Slope compacted crushed limestone away from foundation walls ~1/8" per linear foot so rainwater drains cleanly.

Next Studio ToolContinue Planning on Duvencioglu

Generate Room-by-Room Paint Gallons & Bucket Splits Next

Convert square-foot remodel scope into exact wall area minus doors/windows, surface coats, and optimal 5-gal + 1-gal bucket buys.

Studio Methodology & Reference Standards

Read full studio formulas →

Deck surface counts 5.5 in nominal boards + 1/8 in drainage spacing plus 10% cut waste with joists on 16-inch centers. Patio Paver Base computes 4 inches compacted crushed stone (~1.35 tons/cu yd) plus 1 inch bedding sand.

Primary US Technical & Botanical Sources

  • American Wood Council DCA 6 Prescriptive Residential Deck Guide
  • Interlocking Concrete Pavement Institute (ICPI) Base Standards

Project & Technical FAQ

How thick does the crushed gravel base need to be under patio pavers?
Walkable backyard patios typically require 4 inches of compacted 3/4-inch crushed angular stone (#57/road base) topped by 1 inch of coarse washed screed sand—increasing to 6–8 inches for driveways.
Why 16 inches on-center instead of 24 inches for composite decking?
Composite deck boards deflect noticeably over heat waves at 24" spans; most manufacturers mandate 16" O.C. joists (and 12" O.C. diagonal framing).
How many screws go into 200 sq ft of 2×6 decking?
Plan roughly two coated deck screws or hidden clips at every joist intersection — typically around 350–450 fasteners per 100 sq ft.

Pair With Next Studio Tool

DIY & Remodel

DIY vs. Pro Remodel

Compare US contractor quotes against DIY material + tool costs, see regional labor multipliers, implicit $/hr savings, and permit flags.

Open Studio
DIY & Remodel

Paint Calculator

Deduct standard US doors and windows automatically, adjust for surface texture and coats, and optimize 5-gal + 1-gal bucket splits.

Open Studio
DIY & Remodel

Flooring & Tile

Factor Straight, Brick, Diagonal (15%), or Herringbone (20%) cut waste alongside thin-set mortar bags, grout lbs, and underlayment rolls.

Open Studio